|
This visualization shows what requirements
set by the user are met. The Requirements
panel (located on the
Properties
tab of the right-side panel)
allows the user to set thresholds for key WLAN parameters, namely
(under the Active
section):
·Minimum TCP upstream
rate (shown as ↑TCP on the legend)
·Minimum TCP downstream
rate (shown as ↓TCP on the legend)
·Minimum UDP upstream
rate (shown as ↑UDP on the legend)
·Minimum UDP downstream
rate (shown as ↓UDP on the legend)
·Minimum actual PHY rate
(shown as APHY on the legend)
·Maximum round-trip time
(shown as RTT on the legend)
The zones where the requirement is not met
are marked with the corresponding legend color. If more than one
requirement is not met, only one color will be used (priority is
given to the requirements closer to the top of the list). If all
the requirements are met, no color overlays will be
displayed.
The meaning of the requirements
listed above is explained in detail in the preceding sections of
the Analyzing
Data – Active Surveys chapter.
|
